Updating Hopper
Two software components work together when you use Hopper. One part is the Cedar Aim app on your phone or tablet, and the other part is the software that runs in Hopper’s embedded processor. Usually the Cedar Aim app updates automatically after you install it on your phone or tablet; newer versions of Cedar Aim generally work with older versions of Hopper’s software.
Updating the Hopper processor’s software is not automatic— you have full control over when Hopper’s software is updated as described below.
Updating Hopper’s software carries some risk of failure, possibly leaving your Hopper non-operational. If this happens CS Astro will fully support you in recovering your Hopper to a good state… but because of this risk you might not want to update Hopper right before you are about to travel to a dark sky site.
Updating the Cedar Aim app
You update the Cedar Aim app on your phone or tablet through the app store you used to install the app. This is usually automatic.
Updating Hopper’s software
Updating the software in Hopper’s embedded processor is a multi-step procedure.
With your mobile device connected to the Internet (over your home WiFi or using mobile data), open the Cedar Aim app. Cedar Aim will check the Clear Skies Astro software update repository and download the Hopper update, if available, to your mobile device storage.
Connect your mobile device to Hopper’s WiFi.
Open the Cedar Aim app (or continue in Cedar Aim from step 1).
In the Cedar Aim menu, enable Advanced.
In the menu, under System, tap Check for Update.
Tap Apply Update.
When the update is complete, tap the Restart Cedar button.
After a minute or so the new version of Cedar will be running on Hopper.
Check the version: Menu, System, About. Tap the ‘view’ button next to Versions.
If you run into any difficulties, please contact us at support@cs-astro.com.